9 nov. 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a crystal oscillator with …

23 dec. 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the .trans. It is …

9 okt. 2024 · Simulating a TRIAC or DIAC in LTspice can be a challenge as these parts do not work straight out of the box. This video shows you how to get the job done.

13 jun. 2019 · Hello, I need to simulate a 3 phase star-delta (Yd11) transformer in LTspice. Any idea of how can I proceed? Thanking in anticipation.

31 dec. 2022 · Does anybody know how to simulate high frequency signal and circuit in proteus? For several hundreds KHz it works well but when signal are in MHz range the circuit does not work. I tried …

22 okt. 2010 · To simulate a mic, use a voltage source that makes the same output as the real mic. To simulate an audio (non-critical) circuit with a transistor you don't have in the library, look up the data …

22 mei 2019 · But how can i simulate those two signals on one same line ? A signal line cannot be at two different voltages at the same time. My circuit designs should be regarded as experimental. …

30 aug. 2017 · If I use Proteus to simulate this simple project, then I have a problem when I use as oscillator for PIC18F4550 an external crystal + PLL internal to get maximum frequency 48MHz.

28 jul. 2021 · I would like to simulate a small signal RF amplifier on VHF. Can LTSpice simulate RF and if so can anyone point me to a tutorial that shows the proper set-up for LTSpice? Thanks...

29 jul. 2017 · I just generated a functional simulation model for a DPDT relay symbol I had previously downloaded (both attached). It includes an approximate 15ms open and close delay to simulate the …