The control system is build around the simple Arduino shield shown to the right, which uses simple 74 series logic to send TTL control signals to the laser diodes used in his rig.

Set the laser to TTL and adjust the light power before connecting the optoTTL device. When the optoTTL is plugged into the BNC port on the laser, the laser output should stop. Press the BURST button ...

Overigens, als je al een zandklok hebt, en als je de meest recente software voor dit apparaat downloadt, kun je je eigen verversingsverloop kiezen en een knop toevoegen, zodat je zandklok de tijd ...

I am using a laser module which I bought from aliexpress .Link regarding that laser is given below: ( https://www.aliexpress.com/item/Laseraxe-450nm-5500mW-5-5W-DIY ...

Lidar, Arduino, Raspberry Pi, TOF, laser en de rest Zelfs wie geen specialist is op dat gebied, kan met een lidar, vast, heen-en-weer gaand of draaiend, en een Arduino (of een Raspberry Pi) heel ver ...

This project turns on and turns off a laser LED after every second. It can also monitor its own supply voltage level. It uses KY-008 Laser LED module.

We can use them to cut things, create laser light shows, and also as a rangefinder. [Ignas] wrote in to tell us about [Berryjam’s] AMAZING write-up on creating an Arduino based laser rangefinder.

An impressive persistence of vision laser projector built using an Arduino and a hard drive case has been demonstrated by a DIY enthusiast.

The YouTube channel DIY Builder has published and created a DIY Arduino laser engraver which is powered by an Arduino Nano development board and is fitted with a 200-250mW 650nm Laser Module ...

Lidar, Arduino, Raspberry Pi, Laser, ToF and more Even without being a specialist in the techniques used, the combination of a lidar, whether fixed, oscillating or rotating, with an Arduino (or a ...